She is new and I still have not used her for this very reason. Whatever it is it hard like hard plastic or fiberboard. Where it is located it would be hard to get a plug to fit snug in there. I may try to dig it out and then deal it. Or I might just get rid of her. Thanks
@john It does look like a Piece of something, from the Molding Process. Is it all the way near the end, of the Vaginal Channel? It kind of looks like it, to me.
I was thinking, if you had some extra TPE, that you could fashion a round “plug,” about 1inch, in diameter, like a Grape…then Lube it up well, and push it all the way in, with a wooden Dowel Rod, to seat it, up there. Then, you would be protected, from any incidental “contact.” Plus, you’d be “sealing” the end of the Channel, from any possible fluid leakage…
Is the Doll new? This should be where the cast for the vagina was attached to the skeleton. you will need to plug it with TPE or something waterproof and body safe to keep water and that out of her. White Vinegar seems to work well to clean dolls to help kill mold and remove stains. I haven't had any issues with it hurting my dolls so far. I would make sure you clean her regularly.
She is new and I still have not used her for this very reason. Whatever it is it hard like hard plastic or fiberboard. Where it is located it would be hard to get a plug to fit snug in there. I may try to dig it out and then deal it. Or I might just get rid of her. Thanks
Is the Doll new? This should be where the cast for the vagina was attached to the skeleton. you will need to plug it with TPE or something waterproof and body safe to keep water and that out of her. White Vinegar seems to work well to clean dolls to help kill mold and remove stains. I haven't had any issues with it hurting my dolls so far. I would make sure you clean her regularly.